-
This Gigabit USB 2.0 Ethernet adapter is a cost effective solution that converts a USB port into a 10/100/1000Base-T Ethernet port. It enables low cost and affordable Gigabit Ethernet network connection to desktop, notebook PC, and embedded system using popular USB ports. No need to purchase an expensive Gigabit network interface card and to spare a PCI or Cardbus slot, just using your existing USB ports and you can upgrade your network connection speed.
Features
- Supports 10/100/1000 Mbps auto-sensing capability
- Supports Auto MDIX (straight and cross network cable auto-detection)
- USB specification 1.0, 1.1 and 2.0 compliant
- Supports USB full and high speed modes with bus power capability
- IEEE 802.3, 802.3u, and 802.3ab (10Base-T, 100Base-TX, and 1000Base-T) compatible
- Supports both full-duplex and half-duplex operation in Fast Ethernet
- Supports Jumbo packet of up to 9KB
- Supports suspend mode and remote wakeup via link-up and magic packet
- Plug and Play Installation
System Requirements
- Pentium III 800MHz or faster PC with USB port
- 256 MB RAM or more
- Windows® 98SE/ME/2000/XP
Package Contents
- Gigabit USB 2.0 Ethernet Adapter x1
- Driver CD x1
- Quick Installation Guide x1
- Windows® 98SE/ME/2000/XP
Specification
| Function | Specification |
Network Standards |
IEEE 802.3, 802.3u, and 802.3ab |
Data Bus |
USB |
LED Indicators |
Link, 1000Mbps |
Power |
Integrates on-chip 3.3V to 2.5V voltage regulator and requires only single power supply: 3.3V |
Network Interface |
Female RJ45 jack supporting Auto MDIX |
Full Duplex |
10BaseT, 100BaseTx, 1000BaseT |
Half Duplex |
10BaseT, 100BaseTx |
RAM |
Embedded 20KB SRAM for RX packet buffering and 20KB SRAM for TX packet buffering |
Operating Temperature |
0 o C to 70 o C |
Operating System Support |
Windows 98SE, ME, 2000, XP |
Certification |
FCC, CE |